Download Free Automotive PDF Workshop, Service & Repair Manuals

Toyota MR2 SW Free Download PDF Factory Service Manual / Repair Manual

Toyota MR2 SW Series Service & Repair Manual

Manual detailing servicing guidelines and repair information for Toyota SW series MR2.


Toyota MR2 SW Series Electrical Wiring Diagrams

Wiring diagrams for SW series MR2.


Toyota MR2 Vehicle Information

The MR2 went through a complete redesign in 1989 (though North America did not receive them until late 1990 as 1991 models). The new car was larger and weighed 350 to 400 pounds (160 to 180 kg) more than its predecessor.



There are many subtle visual differences between the normally aspirated and turbocharged models: including the "turbo" emblem (US) on the rear trunk, a fiberglass engine lid with raised vents, fog lights (though some Japanese and European NA models came with fog lights), and an added interior center storage compartment located between the two seats. All SW20 MR2s came with a staggered wheel setup, with wider wheels and tires in the rear than in the front.



Changes to the suspension geometry, tire sizes and power steering in 1992/93 were made in response to journalist reports that the MR2 was prone to "snap-oversteer". When improper steering inputs were made attempting to correct this non-power-on oversteer, the rear of the MR2 would swing one way, then wildly (and quickly) the other, thus the term "snap" oversteer. Toyota elected to change the MR2 suspension and tires to reduce the likelihood that this would occur, though many drivers would lament the change and claim that it "neutered" the sharp edge the MR2 was known for.

Source: Wikipedia